Seawind 1190 (11.9 METRES / 39ft )
STANDARD SPECIFICATIONS AND EQUIPMENT – OWNERS 3 Cabin Version
- GENERAL:
The 1190 has been developed to meet the evolving needs of modern sailors. The 1190 offers a low maintenance high performing 39ft catamaran with enhanced upwind performance and shallow draft capability offered through retracting daggerboards. Perfect for weekend sails and a great base to begin your offshore cruising dream!
- EXTERIOR / LAMINATE:
- Finish: Full female moulded hulls & decks, exterior gelcoat finish with molded-in non-slip surface on deck areas
- Hull Laminate: Infused polyester resin laminate with vinylester tie layer
- Hull Core Material: PVC closed cell foam core
- Deck Laminate: Vacuum formed polyester resin laminate
- Deck Core Material: PVC closed cell foam core
- General Laminate: Vacuum formed polyester resin laminate
- General Core Material: PVC closed cell foam core
- Laminate specifications are certified to International CE standards
- MAST/BOOM/SAILS:
- Clear anodized aluminium mast and boom. Single Spreader, 7/8 rig
- Standing Rigging :
– Forestay 3/8 (10mm) 1 x 19 Dieform wire.
– Sidestays 3/8 (10mm) 1 x 19 Dieform wire
– Diamonds 5/16 (8mm) 1 x 19 Stainless Steel wire
– Main halyard: 12 mm Spectra rope : Heavy duty shackle
– Jib halyard: 8 mm Spectra rope. Heavy duty shackle
– Topping lift: 8 mm rope, Heavy duty shackle
– Boom outhaul: 10mm Spectra
- Single line reefing, run to helm. Three reefing points with 2 reef lines
– Reef 1 & 3: 10mm rope. Leech/Clew blocks and snap shackle
– Reef 2: 10mm rope. Heavy duty shackle
– Main sheet: 10mm rope
– Main traveller: 8mm rope
– Jib sheet: 10mm rope
- All halyards, reefing lines to be lead back to cockpit through turning blocks, rope clutches
- Fully battened mainsail. Triple stitched reinforced construction. Leach adjustable batten end caps. Fibreglass sail battens
- Mainsail cover with integrated lazy jack system.
- Self-tacking headsail, curved headsail traveller track with end stops. With single line control sheet to cockpit.
- DECK EQUIPMENT:
- Aluminium Hatches & portholes (9 in total)
– 4 x Forward Hatches 470mm x 470mm
– 2 x Mid cabin hatches 470mm x 470mm
– 1 x Port Bathroom window hatch 507mm x 377mm
– 1 x Galley window hatch 507mm x 377mm
– 1 x Aft Cabin window hatch 507mm x 377mm
– 5 x Forward anchor & storage hatches
– 2 x Cockpit storage hatches
- 6 x Docking cleats. Each side : bow, stern & amidships
- 6 x Safety handles around cockpit
- 1 x Heavy duty mooring cleat on forward walkway
- Ventilation: 2 x forward cabin hatch vents
- Mast base turning blocks. All halyards & sail controls to cockpit
- 9x Rope clutches
- Sheet winches : 1 x 40ST – 2 speed self tailing, 2 x 50ST – 2 speed self tailing
- Stanchions/Rails: High quality stanchions, bow rails and stern rails with 3 life-lines. With700mm high lifelines to meet CE requirements
- 2 x transom access gates with pelican hook releases
- 2 x side access gates with pelican hook releases
- Aft swim ladder: folding stainless aft swim ladder
- FORWARD BEAM, CATWALK AND TRAMPOLINES:
- Carbon reinforced fwd beam
- Pelican striker and adjustable cable
- 1 x Mooring plate above foredeck
- 2 x Anchor roller under deck. Permanent stowage position for 45lb Plough (CQR/Delta type) anchor (cheeks 75mm high)
- Catwalk in PVC foam-sandwich fibreglass
- Light weight plastic coated open netted trampolines
- AFT BEAM AND DECK:
- Targa Bar with curved mainsheet track and continuous line traveler control system
- Stainless steel framed slatted seats behind aft beam
- Full width hard top over cockpit
- STEERING SYSTEM:
- Twin helm stations
- 2 X 32” lightweight composite steering wheels
- Both wheels independently linked to steering system. – system offers back-up redundancy
- Retractable dagger boards below deck height when retracted
- Lifting, transom hung rudders
- INTERIOR FINISH:
- Furniture and cabin sides gloss gelcoat finish
- Cabin top lined with light weight internally molded gelcoat liner
- Floors: synthetic timber flooring
- Lightweight cupboard doors and trimmings
- SALOON:
- Lightweight handcrafted saloon table
- Upholstered settee
- Lightweight handcrafted coffee table
- Forward aluminium opening windows
- Saloon side windows in 8mm toughened glass
- Tri folding cockpit doors
- Removable low profile, helm hatches
- GALLEY:
- Spacious galley with coordinated Polystone counter surfaces
- Three (3) burner LPG stove, stainless steel pot holders. Flame failure device to shut off LPG immediately in event of flame going out
- Double bowl stainless steel sink
- Pressure fresh water system
- Refrigerator: Front opening upright fridge 130 litres
- Under bench storage
- Trash bin
- LPG solenoid control in galley
- SLEEPING CABINS:
- Light weight PVC foam cored doors on all private cabins
- Port & Starboard fwd cabins : Each queen sized bed (2050mm x 1540mm)
- Aft Starboard cabin : Double bed (1990mm x 1230mm)
- Mattresses 150mm ( 6” ) foam upholstered
- Cabins lined
- 12volt LED lighting
- Storage/Cupboards
- PORTHEAD:
- Polished light weight PVC foam cored door
- Manual toilet. Discharge via holding tank
- Holding tank built in. Discharge pump out by shore station or directly overboard 130L
- Pipes, skin fittings and sea-cocks are easily accessible and to meet survey requirements
- Vanity basin with pressure water
- Separate shower stall with wall mounted shower head & mixer tap
- Electric shower bilge pump with direct overboard discharge
- Large quantity cupboards / shelves to very high quality
- LIGHTING/ELECTRICAL SYSTEM:
- High quality DC electrical switch panel with circuit breakers, LED indicator lights and voltage display
- Marine grade tinned electrical wiring with extensive use of heat sealed connectors
- Batteries x 2 comprising House System (270 amp hrs). One engine cranking battery – 130 amp hr heavy duty battery
- 230amp heavy duty isolation switch
- 12V lighting : Numerous 12V interior lamps and courtesy lights throughout including recessed lights in cockpit
- 4 x 12V Outlets
- CE approved navigation lights. Port & Starboard mounted on bow rails
- Deck floodlight mounted on spreaders
- Mast head anchor / riding light.
- PUMBING /FRESH WATER TANKS:
- Pressure water system with water to galley and bathroom
- Fresh water tank: 700 litres( 185gallons) rotomoulded. Remote deck filler
- Electric fresh water pump
- Electric bilge pumps (2) with controls integral with master battery switch panel
- Manual bilge pumps (2) in each hull
- Marelon through-hull fittings to CE/ISO standard
- Manual toilet in head
- 1 x LPG bottle – 4.5kg
- Fresh water tank gauge
- ENGINES:
- Twin lightweight Honda 20hp 20” engines. Mounted under each helm seat at each steering station
- 5” leg extensions added to engines to reduce cavitation
- Remote electric key start with electric tilt fitted
- Dual engine controls at port helm station
- 270l fuel tank mounted in external locker fwd of mast
- NAVIGATION:
- ANCHORING /MOORING:
- Primary anchor is 45 lb CQR anchor type with 55 mtrs x 8mm short link galvanised chain and 40 mtrsx 16mm triple braid anchor warp
- Primary anchor is stored in a specially designed anchor roller under the forward beam
- 3 x PVC Inflatable Fenders
- 3 x Mooring lines (each 15 metres x 14mm)
- ANTIFOULING / STRIPING:
- Epoxy barrier coat plus 2 coats of high quality black antifouling bottom paint
- Seawind 1190 decal on each hull and stern
DISCLAIMER: The specifications above may change at Seawind Catamaran’s discretion.